Bluewello Strong RO Antiscalant

Description

BlueWello Strong RO Antiscalant

Strong RO Antiscalant: High Silica Inhibition is a specialized, heavy-duty pretreatment chemical engineered to prevent “glass-like” silica scaling on Reverse Osmosis (RO) membranes. Designed for challenging water conditions, it allows systems to operate reliably even when feed water contains high concentrations of dissolved silica. It is the ultimate insurance policy for your membranes in high-TDS or volcanic soil environments.

Advantages

1. High-Recovery Efficiency
   Specifically formulated to allow RO systems to operate at higher recovery rates, reducing water wastage compared to standard antiscalants.

2. Broad-Spectrum Control
   Effectively inhibits a wide range of scales, including Calcium Carbonate, Silica, Iron, and Sulphates, where others often fail on silica.

3. Membrane Longevity
   Our “Advance Liquid Chemestry” technology prevents crystal growth on membrane surfaces, extending membrane life by up to 50% and reducing cleaning frequency.

4. Eco-Safe & Biodegradable
   Unlike many industrial chemicals, Bluewello uses biodegradable organic polymers that are environmentally responsible.

5. Cost-Effective Dosing
   Highly concentrated formula—requires lower dosage (typically 2–4 ppm) than traditional SHMP-based products, saving you money per liter treated.

   Suggested Dosage

Technical Specification

Instructions for Use

1. Handling

• Wear protective gloves and eye protection.
• Avoid direct contact with skin and eyes.
• Wash hands thoroughly after handling.

2. Safety

• Use in a well-ventilated area.
• In case of contact with eyes, rinse immediately with plenty of water and seek medical advice.
• If swallowed, do not induce vomiting; seek medical attention immediately.

3. Storage

• Store in a cool, dry place away from direct sunlight.
• Keep container tightly closed when not in use.
• Store away from incompatible materials such as strong acids and oxidizers.

4. Doses (2-5 ppm)

• The recommended dose of BlueWello Strong RO Antiscalnt is 2-5 ppm (please refer the table).
• Adjust dosing based on water quality and system requirements suggested in adjacent dosage table.

5. Solution Preparation

• Dilute the required amount of BlueWello Strong in clean RO Permeate/Product water before adding to the system.
• Mix thoroughly to ensure a uniform solution.

6. Instream Feeding

• Add the prepared solution directly to the feedwater stream.
• Ensure consistent dosing using a metering pump for optimal performance.